Plastic mixer

Plastic mixer, also known as: plastic mixer, plastic mixer, plastic mixer, Master Mixer, plastic mixing machine, plastic mixing machine, because it is designed for the plastics industry, a product, mainly for plastic Color mixing, the reason why plastic mixer.
Vertical mixer machine Features Four-wheel upright design, small size, easy to move; Equipped with the ideal cycloid reducer motor and mixing paddle directly connected, stir, the paddle can be removed for cleaning; stainless steel barrel, the material Convenient, easy to clean; equipped with AC contactor, overheat protection device; timer can be 0 to 30 minutes to choose Ze mixing time
Day macro plastic mixer use 1. Rihong brand plastic mixer, used in the plastic industry for plastic particles mixed, so that different plastics mixed evenly, the use of motor deceleration, and the plastic mixer in the mixing process does not produce material dissolved, volatile or deterioration.
Ningbo Rihong plastic mixer structure features 1. The overall frame, solid structure, stable operation, mixing paddle and material contact with stainless steel, with good corrosion resistance, to maintain the quality of the material and clean, not discoloration . 2. The transmission adopts the vertical agitating paddle driven by the geared motor to directly drive. When it is in use, it has no excessive loud noise and enough oil storage capacity to get good lubrication.
Acer plastic mixer structure Description 1. The decelerator is the main driving structure of the mixer. It is located in the lower part of the barrel. When it is working, the reducer is installed in the machine base. The shaft is hollow and fixed with a key. The stirring paddle of the plastic mixer can be freely assembled and disassembled. 2. The barrel is a three-dimensional, stainless steel, vertical stirring blades, it stands on the reducer 0.3. Reverse gear reducer, located at the bottom of the work by the device in the base of the motor with a drive worm drive mixing bucket impeller rotation clockwise, so that a material discharge 0.4. The base and the motor device are an integral structure. The motor is installed at the lowest part of the bottom of the bucket. The motor directly drives the stirring blades to maintain the driving force of 0.5. Box is to control the movement of the machine, it is located in front of the right, the drive slot machine can be mixed plastic machine "on" "under" button, be careful not to both
Japan and Hong plastic parts lubrication according to the degree of use, the general should be 1 to 3 months on the reducer ZL-2 lithium-based grease, 6 months to replace.
Nikko Plastic Mixer Instructions for use and precautions 1. Before use should be carried out a run-time test, the test machine should be checked before the plastic mixer all the connections of the firmness, reducer oil and electrical equipment within the integrity of the oil, and then close the main switch, access Power, air transport test machine (note the direction of operation) 0.2. Empty run test. In the absence of abnormal sound machine, bearing high fever, reducer temperature rise and other adverse phenomena, the plastic mixer can be put into production 0.3. If you need to scrape the wall material in the machine during operation, you should not use the bamboo tools, so as to avoid injuries. In use, such as the discovery of abnormal vibration or abnormal noise issued by the machine, should immediately stop the plastic mixer to conduct a comprehensive inspection 0.5. Do not use the load is too large, usually to determine the load on the motor, 380V motor in the mixed plastic heavy current, not more than 6 amps as normal, such as over load should immediately reduce the mixing capacity of 0.6. Stir the paddle at both ends of the shaft seal should be kept clean, so as to avoid plastic blackening, metamorphism, both sides of the mixing tank left square hole, should be smooth, do not make the plastic mixer jam, so as not to play the role of anti-pressure, so that Dirt into the axis, the barrel of black material, metamorphic 0.7. Managers must be familiar with the technical properties of plastic mixers, the internal structure, the control structure and the use of principles. During operation may not leave the work place to prevent damage and damage parts, to ensure safe production as a precondition.